Properties of organic coatings on steel sheet

The two tables compare organic finishes for coated steel sheet. The first describes the uses and characteristics of five common finishes. The second reproduces the grades and figures in SteelProfil’s June 2016 comparison, including coating thickness, forming behaviour and resistance to exposure. It can help narrow down materials to investigate. To specify a roof or facade, use the manufacturer’s data sheet for the actual finish, especially for bending, outdoor exposure and maximum service temperature. The grades A to F below belong to the historical comparison.

Typical characteristics

Polyester (SP) Good formability, decorative finish and weather resistance.
Silicone-modified polyester (SP-SI), matt example Good weather resistance and more limited formability. The original guide gives different heat limits in its two tables.
Polyvinylidene fluoride (PVDF) Good to very good formability, strong outdoor weathering performance and resistance to chalking. Commonly chosen where colour retention matters.
PVC plastisol (PVC-P) Good formability and corrosion resistance. Weathering and colour retention depend on the ultraviolet exposure and the formulation.
PVC film (PVC-F) A film finish with some properties similar to plastisol. The guide lists interior decorative applications.

Comparison published in June 2016

Property SP SP-SI HDP PVDF PVC-P PVC-F
Coating thickness (µm) 25 25 25 25 100-200 100-200
Gloss range 10…80 20…80 20…80 20…40 45…70 5…15
Surface hardness B B B C E D
Maximum temperature under intermittent exposure (°C) 80 100 80 110 60 60
Formability in bending (T-bend) C E B A A A
Formability in roll forming B C B A A A
Formability in deep drawing C F B A B B
Abrasion resistance D E D C A A
Outdoor weathering and UV resistance D D C A E E
Corrosion resistance in the atmosphere C C C B A D

How to read the figures

Grades in this comparison run from A (excellent), B (very good), C (good), D (satisfactory) and E (adequate) to F (unsuitable or not used). Colour availability can vary by finish.

The 2016 comparison lists 100 °C for SP-SI, while its accompanying description gives 110 °C. Obtain the limit for the actual product and exposure duration from its manufacturer.

The UV rating considers colour, gloss retention and chalking together. Corrosion performance refers to the complete coated sheet in an aggressive atmosphere. The original guide also refers to class III under the historical DIN 55928, Part 8, for the finishes other than SP. Use the product’s current declaration for a project specification.